What you need:
Part 2 (16 "in length), a favorite semi-precious stones of 3-4 mm rondels
Two round beads 12-14 mm crystal open (silver or gold metallic)
Two beadcaps (silver or gold metallic)
A pair of ear wires (silver or gold metallic)
6 "24 gauge (silver or gold metallic)
24 microns (1 x 1 mm) linkers
1.5 m and 0.013 Beadalon
Nose pliers
Round nose pliers
Wire Cutters
Instructions:
First) Start by pulling all Beadalon pad. Measure the total length when finished. It should be about 32 ".
II) Next, cut beads strung into 12 equal segments. Each piece measures approximately 2 3 / 4 "long. Beadalon Be sure to leave extra at each end for crimping.
3) Now take a 6 "wire and cut it in two 3 'segment. Make a loop of wire wrapped, each piece of wire.
4). Rondel crimp each segment at one end with a micro-shrinkage, so that the balls are secured to one side.
5) Now begins the other end of the 6 segments each crimp wire wrapped on two cycles you've done with the thread.
6) When all the 12 segments with a crimped (6 for each cycle) string beadcap through the cable so that it fits over the top of the circle of filaments and the pressure to hide. Slide the glass beads.
7) Make a wire wrapped ring Once everything is hooked the wire. The wire wrapped wire loop attached to the ears.
8). Wear and enjoy!
